AIM
4/3/14
5−4−5
Arrival Procedures
5
−
4
−
5. Instrument Approach Procedure
Charts
a.
14 CFR Section 91.175(a), Instrument ap-
proaches to civil airports, requires the use of SIAPs
prescribed for the airport in 14 CFR Part 97 unless
otherwise authorized by the Administrator (including
ATC). If there are military procedures published at a
civil airport, aircraft operating under 14 CFR Part 91
must use the civil procedure(s). Civil procedures are
defined with “FAA” in parenthesis; e.g., (FAA), at the
top, center of the procedure chart. DOD procedures
are defined using the abbreviation of the applicable
military service in parenthesis; e.g., (USAF), (USN),
(USA). 14 CFR Section 91.175(g), Military airports,
requires civil pilots flying into or out of military
airports to comply with the IAPs and takeoff and
landing minimums prescribed by the authority
having jurisdiction at those airports. Unless an
emergency exists, civil aircraft operating at military
airports normally require advance authorization,
commonly referred to as “Prior Permission
Required” or “PPR.” Information on obtaining a PPR
for a particular military airport can be found in the
Airport/Facility Directory.
NOTE
−
Civil aircraft may conduct practice VFR approaches using
DOD instrument approach procedures when approved by
the air traffic controller.
1.
IAPs (standard and special, civil and military)
are based on joint civil and military criteria contained
in the U.S. Standard for TERPS. The design of IAPs
based on criteria contained in TERPS, takes into
account the interrelationship between airports,
facilities, and the surrounding environment, terrain,
obstacles, noise sensitivity, etc. Appropriate
altitudes, courses, headings, distances, and other
limitations are specified and, once approved, the
procedures are published and distributed by
government and commercial cartographers as
instrument approach charts.
2.
Not all IAPs are published in chart form.
Radar IAPs are established where requirements and
facilities exist but they are printed in tabular form in
appropriate U.S. Government Flight Information
Publications.
3.
The navigation equipment required to join
and fly an instrument approach procedure is indicated
by the title of the procedure and notes on the chart.
(a)
Straight−in IAPs are identified by the
navigational system providing the final approach
guidance and the runway to which the approach is
aligned (e.g., VOR RWY 13). Circling only
approaches are identified by the navigational system
providing final approach guidance and a letter
(e.g., VOR A). More than one navigational system
separated by a slash indicates that more than one type
of equipment must be used to execute the final
approach (e.g., VOR/DME RWY 31). More than one
navigational system separated by the word “or” indi-
cates either type of equipment may be used to execute
the final approach (e.g., VOR or GPS RWY 15).
(b)
In some cases, other types of navigation
systems including radar may be required to execute
other portions of the approach or to navigate to the
IAF (e.g., an NDB procedure turn to an ILS, an NDB
in the missed approach, or radar required to join the
procedure or identify a fix). When radar or other
equipment is required for procedure entry from the
en route environment, a note will be charted in the
planview of the approach procedure chart
(e.g., RADAR REQUIRED or ADF REQUIRED).
When radar or other equipment is required on
portions of the procedure outside the final approach
segment, including the missed approach, a note will
be charted in the notes box of the pilot briefing
portion of the approach chart (e.g., RADAR
REQUIRED or DME REQUIRED). Notes are not
charted when VOR is required outside the final
approach segment. Pilots should ensure that the
aircraft is equipped with the required NAVAID(s) in
order to execute the approach, including the missed
approach.
NOTE
−
Some military (i.e., U.S. Air Force and U.S. Navy)
IAPs have these “additional equipment required”
notes charted only in the planview of the approach
procedure and do not conform to the same application
standards used by the FAA.
(c)
The FAA has initiated a program to
provide a new notation for LOC approaches when
charted on an ILS approach requiring other
navigational aids to fly the final approach course. The
LOC minimums will be annotated with the NAVAID
required (e.g., “DME Required” or “RADAR
Required”). During the transition period, ILS
approaches will still exist without the annotation.
(d)
Many ILS approaches having minima
based on RVR are eligible for a landing minimum of