Previous Page Page 383 Next Page  
background image

AIM

4/3/14

5−4−61

Arrival Procedures

j.

ATC will clear aircraft for a CVFP after the pilot

reports siting a charted landmark or a preceding

aircraft. If instructed to follow a preceding aircraft,

pilots are responsible for maintaining a safe approach

interval and wake turbulence separation.

k.

Pilots should advise ATC if at any point they are

unable to continue an approach or lose sight of a

preceding aircraft. Missed approaches will be

handled as a go−around.

5

4

25. Contact Approach

a.

Pilots operating in accordance with an IFR

flight plan, provided they are clear of clouds and have

at least 1 mile flight visibility and can reasonably

expect to continue to the destination airport in those

conditions, may request ATC authorization for a

contact approach.

b.

Controllers may authorize a contact approach

provided:

1.

The contact approach is specifically

requested by the pilot. ATC cannot initiate this

approach.

EXAMPLE

Request contact approach.

2.

The reported ground visibility at the

destination airport is at least 1 statute mile.

3.

The contact approach will be made to an

airport having a standard or special instrument

approach procedure.

4.

Approved separation is applied between

aircraft so cleared and between these aircraft and

other IFR or special VFR aircraft.

EXAMPLE

Cleared contact approach (and, if required) at or below
(altitude) (routing) if not possible (alternative procedures)
and advise.

c.

A contact approach is an approach procedure

that may be used by a pilot (with prior authorization

from ATC) in lieu of conducting a standard or special

IAP to an airport. It is not intended for use by a pilot

on an IFR flight clearance to operate to an airport not

having a published and functioning IAP. Nor is it

intended for an aircraft to conduct an instrument

approach to one airport and then, when “in the clear,”

discontinue that approach and proceed to another

airport. In the execution of a contact approach, the

pilot assumes the responsibility for obstruction

clearance. If radar service is being received, it will

automatically terminate when the pilot is instructed to

change to advisory frequency.

5

4

26. Landing Priority

A clearance for a specific type of approach (ILS,

MLS, ADF, VOR or Straight−in Approach) to an

aircraft operating on an IFR flight plan does not mean

that landing priority will be given over other traffic.

ATCTs handle all aircraft, regardless of the type of

flight plan, on a “first−come, first−served” basis.

Therefore, because of local traffic or runway in use,

it may be necessary for the controller in the interest

of safety, to provide a different landing sequence. In

any case, a landing sequence will be issued to each

aircraft as soon as possible to enable the pilot to

properly adjust the aircraft’s flight path.

5

4

27. Overhead Approach Maneuver

a.

Pilots operating in accordance with an

IFR flight plan in Visual Meteorological

Conditions (VMC) may request ATC authorization

for an overhead maneuver. An overhead maneuver is

not an instrument approach procedure. Overhead

maneuver patterns are developed at airports where

aircraft have an operational need to conduct the

maneuver. An aircraft conducting an overhead

maneuver is considered to be VFR and the IFR flight

plan is cancelled when the aircraft reaches the initial

point on the initial approach portion of the maneuver.

(See FIG 5−4−32.) The existence of a standard

overhead maneuver pattern does not eliminate the

possible requirement for an aircraft to conform to

conventional rectangular patterns if an overhead

maneuver cannot be approved. Aircraft operating to

an airport without a functioning control tower must

initiate cancellation of an IFR flight plan prior to

executing the overhead maneuver. Cancellation of

the IFR flight plan must be accomplished after

crossing the landing threshold on the initial portion of

the maneuver or after landing. Controllers may

authorize an overhead maneuver and issue the

following to arriving aircraft:

1.

Pattern altitude and direction of traffic. This

information may be omitted if either is standard.

PHRASEOLOGY

PATTERN ALTITUDE (altitude). RIGHT TURNS.

  Previous Page Page 383 Next Page