REFERENCE-
AIM, Paragraph 5-3-8 j2, Holding

4. The absence of the procedure turn barb in the
plan view indicates that a procedure turn is not
authorized for that procedure.
5-4-10. Timed Approaches from a Holding
Fix
a. TIMED APPROACHES may be conducted
when the following conditions are met:
1. A control tower is in operation at the airport
where the approaches are conducted.
2. Direct communications are maintained between the pilot and the center or approach controller
until the pilot is instructed to contact the tower.
3. If more than one missed approach procedure
is available, none require a course reversal.
4. If only one missed approach procedure is
available, the following conditions are met:
(a) Course reversal is not required; and,

Arrival Procedures

(b) Reported ceiling and visibility are equal
to or greater than the highest prescribed circling
minimums for the IAP.
5. When cleared for the approach, pilots must
not execute a procedure turn. (14 CFR Section 91.175.)
b. Although the controller will not specifically
state that "timed approaches are in use," the assigning
of a time to depart the final approach fix inbound
(nonprecision approach) or the outer marker or fix
used in lieu of the outer marker inbound (precision
approach) is indicative that timed approach procedures are being utilized, or in lieu of holding, the
controller may use radar vectors to the Final
Approach Course to establish a mileage interval
between aircraft that will ensure the appropriate time
sequence between the final approach fix/outer marker
or fix used in lieu of the outer marker and the airport.
c. Each pilot in an approach sequence will be given
advance notice as to the time they should leave the
holding point on approach to the airport. When a time
to leave the holding point has been received, the pilot
should adjust the flight path to leave the fix as closely
as possible to the designated time. (See FIG 5-4-19.)

5-4-33