583
Federal Aviation Administration, DOT
§ 29.143
complete power failure occurs during
normal cruise.
[Doc. No. 24802, 61 FR 21900, May 10, 1996; 61
FR 33963, July 1, 1996]
§ 29.85
Balked landing: Category A.
For Category A rotorcraft, the
balked landing path with the critical
engine inoperative must be established
so that—
(a) The transition from each stage of
the maneuver to the next stage can be
made smoothly and safely;
(b) From the LDP on the approach
path selected by the applicant, a safe
climbout can be made at speeds allow-
ing compliance with the climb require-
ments of § 29.67(a)(1) and (2); and
(c) The rotorcraft does not descend
below 15 feet above the landing surface.
For elevated heliport operations, de-
scent may be below the level of the
landing surface provided the deck edge
clearance of § 29.60 is maintained and
the descent (loss of height) below the
landing surface is determined.
[Doc. No. 24802, 64 FR 45338, Aug. 19, 1999]
§ 29.87
Height-velocity envelope.
(a) If there is any combination of
height and forward velocity (including
hover) under which a safe landing can-
not be made after failure of the critical
engine and with the remaining engines
(where applicable) operating within ap-
proved limits, a height-velocity enve-
lope must be established for—
(1) All combinations of pressure alti-
tude and ambient temperature for
which takeoff and landing are ap-
proved; and
(2) Weight from the maximum weight
(at sea level) to the highest weight ap-
proved for takeoff and landing at each
altitude. For helicopters, this weight
need not exceed the highest weight al-
lowing hovering out-of-ground effect at
each altitude.
(b) For single-engine or multiengine
rotorcraft that do not meet the Cat-
egory A engine isolation requirements,
the height-velocity envelope for com-
plete power failure must be estab-
lished.
[Doc. No. 24802, 61 FR 21901, May 10, 1996; 61
FR 33963, July 1, 1996]
F
LIGHT
C
HARACTERISTICS
§ 29.141
General.
The rotorcraft must—
(a) Except as specifically required in
the applicable section, meet the flight
characteristics requirements of this
subpart—
(1) At the approved operating alti-
tudes and temperatures;
(2) Under any critical loading condi-
tion within the range of weights and
centers of gravity for which certifi-
cation is requested; and
(3) For power-on operations, under
any condition of speed, power, and
rotor r.p.m. for which certification is
requested; and
(4) For power-off operations, under
any condition of speed, and rotor r.p.m.
for which certification is requested
that is attainable with the controls
rigged in accordance with the approved
rigging instructions and tolerances;
(b) Be able to maintain any required
flight condition and make a smooth
transition from any flight condition to
any other flight condition without ex-
ceptional piloting skill, alertness, or
strength, and without danger of ex-
ceeding the limit load factor under any
operating condition probable for the
type, including—
(1) Sudden failure of one engine, for
multiengine rotorcraft meeting Trans-
port Category A engine isolation re-
quirements;
(2) Sudden, complete power failure,
for other rotorcraft; and
(3) Sudden, complete control system
failures specified in § 29.695 of this part;
and
(c) Have any additional characteris-
tics required for night or instrument
operation, if certification for those
kinds of operation is requested. Re-
quirements for helicopter instrument
flight are contained in appendix B of
this part.
[Doc. No. 5084, 29 FR 16150, Dec. 8, 1964, as
amended by Amdt. 29–3, 33 FR 905, Jan. 26,
1968; Amdt. 29–12, 41 FR 55471, Dec. 20, 1976;
Amdt. 29–21, 48 FR 4391, Jan. 31, 1983; Amdt.
29–24, 49 FR 44436, Nov. 6, 1984]
§ 29.143
Controllability and maneuver-
ability.
(a) The rotorcraft must be safely con-
trollable and maneuverable—
VerDate Sep<11>2014
12:50 Apr 30, 2019
Jkt 247046
PO 00000
Frm 00593
Fmt 8010
Sfmt 8010
Y:\SGML\247046.XXX
247046
spaschal on DSK3GDR082PROD with CFR