Pt. 36, App. A

Section A36.5 Reporting of Data to the FAA

A36.5.2.1 The applicant must present measured and corrected sound pressure levels in
one-third octave band levels that are obtained with equipment conforming to the
standards described in section A36.3 of this
appendix.
A36.5.2.2 The applicant must report the
make and model of equipment used for measurement and analysis of all acoustic performance and meteorological data.
A36.5.2.3 The applicant must report the following atmospheric environmental data, as
measured immediately before, after, or during each test at the observation points prescribed in section A36.2 of this appendix.
(a) Air temperature and relative humidity;
(b) Maximum, minimum and average wind
velocities; and
(c) Atmospheric pressure.

A36.5.1 General.
A36.5.1.1 Data representing physical measurements and data used to make corrections
to physical measurements must be recorded
in an approved permanent form and appended to the record.
A36.5.1.2 All corrections must be reported
to and approved by the FAA, including corrections to measurements for equipment response deviations.
A36.5.1.3 Applicants may be required to
submit estimates of the individual errors inherent in each of the operations employed in
obtaining the final data.
A36.5.2 Data reporting.
An applicant is required to submit a noise
certification compliance report that includes
the following.

791

VerDate Sep<11>2014

12:50 Apr 30, 2019

Jkt 247046

PO 00000

Frm 00801

Fmt 8010

Sfmt 8002

Y:\SGML\247046.XXX

247046

ER08JY02.009</GPH>

spaschal on DSK3GDR082PROD with CFR

Federal Aviation Administration, DOT