Pt. 60, App. A

14 CFR Ch. I (1-1-19 Edition)

kpayne on VMOFRWIN702 with $$_JOB

FSTD-s fidelity level during the maneuver.
The cross-plot or other alternative method
must display the relevant validity regions
for flaps up and flaps down at a minimum.
This validation envelope must be derived
by the aerodynamic data provider or derived using information and data sources
provided by the original aerodynamic data
provider.
b. Flight Control Inputs: The FSTD must
employ a method for the instructor/evaluator to assess the trainee-s flight control
inputs during the upset recovery maneuver. Additional parameters, such as cockpit control forces (forces applied by the
pilot to the controls) and the flight control
law mode for fly-by-wire aircraft, must be
portrayed in this feedback mechanism as
well. For passive sidesticks, whose displacement is the flight control input, the
force applied by the pilot to the controls
does not need to be displayed. This tool
must include a time history or other equivalent method of recording flight control
positions.
c. Aircraft Operational Limits: The FSTD
must employ a method to provide the instructor/evaluator with real-time information concerning the aircraft operating limits. The simulated aircraft-s parameters
must be displayed dynamically in real-

time and also provided in a time history or
equivalent format. At a minimum, the following parameters must be available to the
instructor:
i. Airspeed and airspeed limits, including the
stall speed and maximum operating limit
airspeed (Vmo/Mmo);
ii. Load factor and operational load factor
limits; and
iii. Angle of attack and the stall identification angle of attack. See section A, paragraph 4.b. of this attachment for additional
information concerning the definition of
the stall identification angle of attack.
This parameter may be displayed in conjunction with the FSTD validation envelope.
END QPS REQUIREMENTS
BEGIN INFORMATION
An example FSTD  - alpha/beta -  envelope
display and IOS feedback mechanism are
shown below in Figure 1 and Figure 2. The
following examples are provided as guidance
material on one possible method to display
the required UPRT feedback parameters on
an IOS display. FSTD sponsors may develop
other methods and feedback mechanisms
that provide the required parameters and
support the training program objectives.

184

VerDate Sep<11>2014

16:30 Jun 25, 2019

Jkt 247047

PO 00000

Frm 00194

Fmt 8010

Sfmt 8002

Q:\14\14V2.TXT

PC31