191 

Federal Aviation Administration, DOT 

Pt. 60, App. B 

this reason that the NSPM recommends that 
any data supplier not previously experienced 
in this area review the data necessary for 
programming and for validating the perform-
ance of the FTD and discuss the flight test 
plan anticipated for acquiring such data with 
the NSPM well in advance of commencing 
the flight tests. 

i. The NSPM will consider, on a case-by- 

case basis, whether to approve supplemental 
validation data derived from flight data re-
cording systems such as a Quick Access Re-
corder or Flight Data Recorder. 

E

ND

I

NFORMATION

 

lllllllllllllllllllllll

10. S

PECIAL

E

QUIPMENT AND

P

ERSONNEL

R

E

 

QUIREMENTS FOR

Q

UALIFICATION OF THE

FTD 

(§ 60.14). 

lllllllllllllllllllllll

B

EGIN

I

NFORMATION

 

a. In the event that the NSPM determines 

that special equipment or specifically quali-
fied persons will be required to conduct an 
evaluation, the NSPM will make every at-
tempt to notify the sponsor at least one (1) 
week, but in no case less than 72 hours, in 
advance of the evaluation. Examples of spe-
cial equipment include flight control meas-
urement devices, accelerometers, or oscillo-
scopes. Examples of specially qualified per-
sonnel include individuals specifically quali-
fied to install or use any special equipment 
when its use is required. 

b. Examples of a special evaluation include 

an evaluation conducted after: An FTD is 
moved; at the request of the TPAA; or as a 
result of comments received from users of 
the FTD that raise questions about the con-
tinued qualification or use of the FTD. 

E

ND

I

NFORMATION

 

lllllllllllllllllllllll

11. I

NITIAL

(

AND

U

PGRADE

) Q

UALIFICATION

 

R

EQUIREMENTS

(§ 60.15). 

lllllllllllllllllllllll

B

EGIN

QPS R

EQUIREMENT

 

a. In order to be qualified at a particular 

qualification level, the FTD must: 

(1) Meet the general requirements listed in 

Attachment 1 of this appendix; 

(2) Meet the objective testing requirements 

listed in Attachment 2 of this appendix 
(Level 4 FTDs do not require objective tests); 
and 

(3) Satisfactorily accomplish the subjec-

tive tests listed in Attachment 3 of this ap-
pendix. 

b. The request described in § 60.15(a) must 

include all of the following: 

(1) A statement that the FTD meets all of 

the applicable provisions of this part and all 
applicable provisions of the QPS. 

(2) Unless otherwise authorized through 

prior coordination with the NSPM, a con-
firmation that the sponsor will forward to 
the NSPM the statement described in 
§ 60.15(b) in such time as to be received no 
later than 5 business days prior to the sched-
uled evaluation and may be forwarded to the 
NSPM via traditional or electronic means. 

(3) Except for a Level 4 FTD, a QTG, ac-

ceptable to the NSPM, that includes all of 
the following: 

(a) Objective data obtained from aircraft 

testing or another approved source. 

(b) Correlating objective test results ob-

tained from the performance of the FTD as 
prescribed in the appropriate QPS. 

(c) The result of FTD subjective tests pre-

scribed in the appropriate QPS. 

(d) A description of the equipment nec-

essary to perform the evaluation for initial 
qualification and the continuing qualifica-
tion evaluations. 

c. The QTG described in paragraph a(3) of 

this section, must provide the documented 
proof of compliance with the FTD objective 
tests in Attachment 2, Table B2A of this ap-
pendix. 

d. The QTG is prepared and submitted by 

the sponsor, or the sponsor?s agent on behalf 
of the sponsor, to the NSPM for review and 
approval, and must include, for each objec-
tive test: 

(1) Parameters, tolerances, and flight con-

ditions; 

(2) Pertinent and complete instructions for 

conducting automatic and manual tests; 

(3) A means of comparing the FTD test re-

sults to the objective data; 

(4) Any other information as necessary to 

assist in the evaluation of the test results; 

(5) Other information appropriate to the 

qualification level of the FTD. 

e. The QTG described in paragraphs (a)(3) 

and (b) of this section, must include the fol-
lowing: 

(1) A QTG cover page with sponsor and 

FAA approval signature blocks (see Attach-
ment 4, Figure B4C, of this appendix, for a 
sample QTG cover page). 

(2) [Reserved] 
(3) An FTD information page that provides 

the information listed in this paragraph, if 
applicable (see Attachment 4, Figure B4B, of 
this appendix, for a sample FTD information 
page). For convertible FTDs, the sponsor 
must submit a separate page for each con-
figuration of the FTD. 

(a) The sponsor’s FTD identification num-

ber or code. 

(b) The airplane model and series being 

simulated. 

(c) The aerodynamic data revision number 

or reference. 

VerDate Sep<11>2014 

16:30 Jun 25, 2019

Jkt 247047

PO 00000

Frm 00201

Fmt 8010

Sfmt 8002

Q:\14\14V2.TXT

PC31

kpayne on VMOFRWIN702 with $$_JOB