kpayne on VMOFRWIN702 with $$_JOB VerDate Sep<11>2014 QPS requirements Information Jkt 247047 Test FTD level Tolerances Entry No. Flight conditions Test details Title PO 00000 4. Visual System 4.a. ........................ Visual System Response Time: (Choose either test 4.a.1. or 4.a.2. to satisfy test 4.a., Visual System Response Time Test. This test is also sufficient for flight deck instrument response timing.) 4.a.1. ..................... Latency. Frm 00462 6 7 .... .... Sfmt 8002 Takeoff, climb, and descent. One test is required in each axis (pitch, roll and yaw) for each of the three conditions (take-off, cruise, and approach or landing). X 150 ms (or less) after controller movement. N/A ........................... A separate test is required in each axis (pitch, roll, and yaw). X Field-of-view. 4.b.1. ..................... Reserved. 4.b.2. ..................... Continuous visual fieldof-view. 4.b.3. ..................... Reserved. PC31 4.b. ........................ Minimum continuous field-of-view providing 146Section horizontal and 36Section vertical field-of-view for each pilot simultaneously and any geometric error between the Image Generator eye point and the pilot eye point is 8Section or less. N/A ........................... An SOC is required and must explain the geometry of the installation. Horizontal field-of-view must not be less than a total of 146Section (including not less than 73Section measured either side of the center of the design eye point). Additional horizontal field-ofview capability may be added at the sponsor-s discretion provided the minimum field-of-view is retained. Vertical field-ofview: Not less than a total of 36Section measured from the pilot-s and co-pilot-s eye point. X Horizontal field-of-view is centered on the zero degree azimuth line relative to the aircraft fuselage. 14 CFR Ch. I (1-1-19 Edition) Q:\14\14V2.TXT 150 ms (or less) after helicopter response. Transport Delay. 452 Fmt 8010 4.a.2. ..................... Notes 5 Pt. 60, App. D 16:30 Jun 25, 2019 TABLE D2A - FLIGHT TRAINING DEVICE (FTD) OBJECTIVE TESTS - Continued