814
14 CFR Ch. I (1–1–19 Edition)
§ 171.53
(6) Notice to the Administrator of
any suspension of service.
(7) Detailed and specific maintenance
procedures and servicing guides stating
the frequency of servicing.
(8) Air-ground communications, if
provided, expressly written or incor-
porating appropriate sections of FAA
manuals by reference.
(9) Keeping of station logs and other
technical reports, and the submission
of reports required by § 171.53.
(10) Monitoring of the facility.
(11) Inspections by United States per-
sonnel.
(12) Names, addresses, and telephone
numbers of persons to be notified in an
emergency.
(13) Shutdowns for routine mainte-
nance and issue of ‘‘Notices to Airmen’’
for routine or emergency shutdowns
(private use facilities may omit the
‘‘Notices to Airmen’’).
(14) Commissioning of the facility.
(15) An acceptable procedure for
amending or revising the manual.
(16) An explanation of the kinds of
activities (such as construction or
grading) in the vicinity of the facility
that may require shutdown or recertifi-
cation of the facility by FAA flight
check.
(17) Procedures for conducting a
ground check or localizer course align-
ment width, and clearance, and glide
slope elevation angle and width.
(18) The following information con-
cerning the facility:
(i) Facility component locations with
respect to airport layout, instrument
runway, and similar areas.
(ii) The type, make, and model of the
basic radio equipment that will provide
the service.
(iii) The station power emission and
frequencies of the localizer, glide slope,
markers, and associated compass loca-
tors, if any.
(iv) The hours of operation.
(v) Station identification call letters
and method of station identification
and the time spacing of the identifica-
tion.
(vi) A description of the critical parts
that may not be changed, adjusted, or
repaired without an FAA flight check
to confirm published operations.
(c) The owner shall make a ground
check of the facility each month in ac-
cordance with procedures approved by
the FAA at the time of commissioning,
and shall report the results of the
checks as provided in § 171.53.
(d) If the owner desires to modify the
facility, he must submit the proposal
to the FAA and may not allow any
modifications to be made without spe-
cific approval.
(e) ‘‘The owner’s maintenance per-
sonnel must participate in initial in-
spections made by the FAA. In the case
of subsequent inspections, the owner or
his representative shall participate.’’
(f) Whenever it is required by the
FAA, the owner shall incorporate im-
provements in ILS maintenance
brought about by progress in the state
of the art. In addition, he shall provide
a stock of spare parts, including vacu-
um tubes, of such a quantity to make
possible the prompt replacement of
components that fail or deteriorate in
service.
(g) The owner shall provide FAA ap-
proved test instruments needed for
maintenance of the facility.
(h) The owner shall close the facility
upon receiving two successive pilot re-
ports of its malfunctioning.
[Doc. No. 5034, 29 FR 11337, Aug. 6, 1964, as
amended by Amdt. 171–2, 31 FR 5408, Apr. 6,
1966]
§ 171.53
Reports.
The owner of each facility to which
this subpart applies shall make the fol-
lowing reports, at the times indicated,
to the FAA Regional Office for the area
in which the facility is located:
(a)
Record of meter readings and adjust-
ments
(
Form FAA–198
). To be filled out
by the owner or his maintenance rep-
resentative with the equipment adjust-
ments and meter readings as of the
time of commissioning, with one copy
to be kept in the permanent records of
the facility and two copies to the ap-
propriate Regional Office of the FAA.
The owner shall revise the form after
any major repair, modernization, or re-
tuning, to reflect an accurate record of
facility operation and adjustment.
(b)
Facility maintenance log
(
FormFAA
6030–1
). This form is a permanent
record of all equipment malfunctioning
met in maintaining the facility, in-
cluding information on the kind of
VerDate Sep<11>2014
08:20 May 17, 2019
Jkt 247048
PO 00000
Frm 00824
Fmt 8010
Sfmt 8010
Y:\SGML\247048.XXX
247048