822
14 CFR Ch. I (1–1–19 Edition)
§ 171.115
the event out-of-tolerance conditions
develop, the facility shall be removed
from operation, and the designated
control point notified.
(c) The owner must prepare, and ob-
tain approval of, and each person oper-
ating or maintaining the facility shall
comply with, an operations and main-
tenance manual that sets forth proce-
dures for operations, preventive main-
tenance, and emergency maintenance,
including instructions on each of the
following:
(1) Physical security of the facility.
This includes provisions for desig-
nating critical areas relative to the fa-
cility and preventing or controlling
movements within the facility that
may adversely affect SDF operations.
(2) Maintenance and operations by
authorized persons only.
(3) Federal Communications Commis-
sion requirements for operating per-
sonnel and maintenance personnel.
(4) Posting of licenses and signs.
(5) Relation between the facility and
Federal Aviation Administration air
traffic control facilities, with a de-
scription of the boundaries of con-
trolled airspace over or near the facil-
ity, instructions for relaying air traffic
control instructions and information
(if applicable), and instructions for the
operation of an air traffic advisory
service if the facility is located outside
of controlled airspace.
(6) Notice to the Administrator of
any suspension of service.
(7) Detailed and specific maintenance
procedures and servicing guides stating
the frequency of servicing.
(8) Air-ground communications, if
provided, expressly written or incor-
porating appropriate sections of Fed-
eral Aviation Administration manuals
by reference.
(9) Keeping of station logs and other
technical reports, and the submission
of reports required by § 171.117.
(10) Monitoring of the facility.
(11) Names, addresses, and telephone
numbers of persons to be notified in an
emergency.
(12) Inspection by U.S. personnel.
(13) Shutdowns for routine mainte-
nance and issue of ‘‘Notices to Airmen’’
for routine or emergency shutdowns,
except that private use facilities may
omit ‘‘Notices to Airmen.’’
(14) Commissioning of the facility.
(15) An acceptable procedure for
amending or revising the manual.
(16) An explanation of the kinds of
activities (such as construction or
grading) in the vicinity of the facility
that may require shutdown or certifi-
cation of the facility by Federal Avia-
tion Administration flight check.
(17) Procedure for conducting a
ground check of SDF course alignment,
width and clearance.
(18) The following information con-
cerning the facility:
(i) Facility component locations with
respect to airport layout, instrument
runway, and similar areas;
(ii) The type, make, and model of the
basic radio equipment that will provide
the service;
(iii) The station power emission and
frequencies of the SDF, markers and
associated COMLOs, if any;
(iv) The hours of operation;
(v) Station identification call letters
and method of station identification
and the time spacing of the identifica-
tion;
(vi) A description of the critical parts
that may not be changed, adjusted, or
repaired without a Federal Aviation
Administration flight check to confirm
published operations.
(d) The owner shall make a ground
check of the facility each month in ac-
cordance with procedures approved by
the Federal Aviation Administration
at the time of commissioning, and
shall report the results of the checks as
provided in § 171.117.
(e) If the owner desires to modify the
facility, he shall submit the proposal
to the Federal Aviation Administra-
tion and may not allow any modifica-
tions to be made without specific ap-
proval.
(f) The owner’s maintenance per-
sonnel shall participate in initial in-
spections made by the Federal Avia-
tion Administration. In the case of sub-
sequent inspections, the owner or his
representatives shall participate.
(g) Whenever it is required by the
Federal Aviation Administration, the
owner shall incorporate improvements
in SDF maintenance. In addition, he
shall provide a stock of spare parts, of
such a quantity, to make possible the
VerDate Sep<11>2014
08:20 May 17, 2019
Jkt 247048
PO 00000
Frm 00832
Fmt 8010
Sfmt 8010
Y:\SGML\247048.XXX
247048