Section 171.115

14 CFR Ch. I (1-1-19 Edition)

the event out-of-tolerance conditions
develop, the facility shall be removed
from operation, and the designated
control point notified.
(c) The owner must prepare, and obtain approval of, and each person operating or maintaining the facility shall
comply with, an operations and maintenance manual that sets forth procedures for operations, preventive maintenance, and emergency maintenance,
including instructions on each of the
following:
(1) Physical security of the facility.
This includes provisions for designating critical areas relative to the facility and preventing or controlling
movements within the facility that
may adversely affect SDF operations.
(2) Maintenance and operations by
authorized persons only.
(3) Federal Communications Commission requirements for operating personnel and maintenance personnel.
(4) Posting of licenses and signs.
(5) Relation between the facility and
Federal Aviation Administration air
traffic control facilities, with a description of the boundaries of controlled airspace over or near the facility, instructions for relaying air traffic
control instructions and information
(if applicable), and instructions for the
operation of an air traffic advisory
service if the facility is located outside
of controlled airspace.
(6) Notice to the Administrator of
any suspension of service.
(7) Detailed and specific maintenance
procedures and servicing guides stating
the frequency of servicing.
(8) Air-ground communications, if
provided, expressly written or incorporating appropriate sections of Federal Aviation Administration manuals
by reference.
(9) Keeping of station logs and other
technical reports, and the submission
of reports required by Section 171.117.
(10) Monitoring of the facility.
(11) Names, addresses, and telephone
numbers of persons to be notified in an
emergency.
(12) Inspection by U.S. personnel.
(13) Shutdowns for routine maintenance and issue of  - Notices to Airmen - 
for routine or emergency shutdowns,
except that private use facilities may
omit  - Notices to Airmen. - 

(14) Commissioning of the facility.
(15) An acceptable procedure for
amending or revising the manual.
(16) An explanation of the kinds of
activities (such as construction or
grading) in the vicinity of the facility
that may require shutdown or certification of the facility by Federal Aviation Administration flight check.
(17) Procedure for conducting a
ground check of SDF course alignment,
width and clearance.
(18) The following information concerning the facility:
(i) Facility component locations with
respect to airport layout, instrument
runway, and similar areas;
(ii) The type, make, and model of the
basic radio equipment that will provide
the service;
(iii) The station power emission and
frequencies of the SDF, markers and
associated COMLOs, if any;
(iv) The hours of operation;
(v) Station identification call letters
and method of station identification
and the time spacing of the identification;
(vi) A description of the critical parts
that may not be changed, adjusted, or
repaired without a Federal Aviation
Administration flight check to confirm
published operations.
(d) The owner shall make a ground
check of the facility each month in accordance with procedures approved by
the Federal Aviation Administration
at the time of commissioning, and
shall report the results of the checks as
provided in Section 171.117.
(e) If the owner desires to modify the
facility, he shall submit the proposal
to the Federal Aviation Administration and may not allow any modifications to be made without specific approval.
(f) The owner-s maintenance personnel shall participate in initial inspections made by the Federal Aviation Administration. In the case of subsequent inspections, the owner or his
representatives shall participate.
(g) Whenever it is required by the
Federal Aviation Administration, the
owner shall incorporate improvements
in SDF maintenance. In addition, he
shall provide a stock of spare parts, of
such a quantity, to make possible the

822

VerDate Sep<11>2014

08:20 May 17, 2019

Jkt 247048

PO 00000

Frm 00832

Fmt 8010

Sfmt 8010

Y:\SGML\247048.XXX

247048